Emulex 110 Guide d'installation télécharger pdf (Page 44)

EMC Host Connecivity with Emulex Fibre Channel HBAs and CNAs in the Windows Environment

Installation and Configuration

Figure 19 Setting the primary boot LUN

A list representing all array targets visible to the adapter is

presented. In this example, a single array is zoned to the adapter.

15. Select the two-digit row number corresponding to the array to be

used for boot (01 in this example) and press Enter.

This displays a screen similar to Figure 20 on page 45.

Note: If no entries (other than 00) appear, verify the following:

• If multiple adapters are present, verify the adapter selected in the

BIOS utility is the same adapter that currently provides the I/O path

to the storage. (At this point, only one I/O path should be configured

to the boot LUN.)

• For VNX

™

series or CLARiiON

systems, verify the single I/O path

points to the SP that owns the boot LUN.

• For FC-SW environments, verify fabric-zoning parameters, such that

a single I/O path exists to the boot LUN. (Refer to your array

software documentation for details.)

• Check the physical Fibre Channel connectivity between the adapter

and array (direct-attach environment) or switch (FC-SW

environment).

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 239 240

Pas de commentaire

Emulex 110 Guide d'installation Page 44