Emulex LightPulse LPe1105-M4 HBA Guide d'installation télécharger pdf (Page 153)

Device reconfiguration procedures

153

Additional Notes

The unloading of the module can be accomplished with the

modprobe (with the

-r switch) command or the rmmod

command. These commands are used to unload the loadable

modules from the running kernel if they are not in use and if

other modules are not dependent upon them.

As mentioned previously, if the Emulex Application Helper

Module is installed and loaded, you must remove it before the

standard Emulex lpfc driver.

• lpfcdfc — The Application Helper Module (lpfcdfc driver)

that is used to communicate with the Emulex adapters and to

query information and perform maintenance on the Emulex

adapters.

• lpfc — The low-level Emulex Linux adapter driver module.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 181 182

Pas de commentaire

Emulex LightPulse LPe1105-M4 HBA Guide d'installation Page 153