Emulex NQTR0V-NATM Manuel d'utilisateur télécharger pdf (Page 66)

2-46 Chapter 2

Print Test Pagearameters

The test page is a helpful tool that can be used to verify the connection

between the printer server and the printer. The test page contains the

following data:

reference when configuring the printer server. The print out contains

default and recently changed informationPrinter sServer nName

MAC Address

efault remote pPrinter nName Node Nname

Hardware & fFirmware revisions NOS iInformation

SSoftware revision Network pProtocols

To print the test page, perform the following steps:

1) Verify the Emulex printer server has power.

2) Verify printer has power and is On-Line.

3) Disconnect power cord to the printer server.

4) Disconnect LAN cable.

5) Reconnect power cord to printer server.

6) The printout will occur within 90 seconds.

If no printout occurs, verify all connections and make sure printer shows

power ON, Ready and On-Line.

NOTE: If the printer is PCL or text only, the test printout

may contain PostScript commands.

Print Configuration Parameters

To obtain a printout of configuration parameters, enter this software

command:

Server>> show server config port port_number [ps]

port_number The output is directed to the specified port number.

ps Puts the output in PostScript format.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 206 207

Pas de commentaire

Emulex NQTR0V-NATM Manuel d'utilisateur Page 66