Emulex NQTR0V-NATM Manuel d'utilisateur télécharger pdf (Page 28)

2-8 Chapter 2

Reset to Factory Defaults

Before resetting to factory defaults, we recommend that you print out a

configuration page. Using the command described below will reset the

printer server to its factory defaults.

• The printer server will reset to factory defaults when power is cycled.

• The IP address and subnet mask are reset to NONE (000.000.000.000).

• Non-volatile memory is reset to factory defaults.

To reset to factory defaults:

1) Obtain privileged status.

2) Enter this command:

Server>> initialize [server] [delay delay_min]

[default]

delay Indicates reintialization will not take place until after a

specified period of time.

delay_min Specifies the time before the server is stopped and

the initialization process begins. The default is 1

minute.

default Resets the server to factory defaults

3) Cycle printer power.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 206 207

Pas de commentaire

Emulex NQTR0V-NATM Manuel d'utilisateur Page 28