Emulex LightPulse LPe12000 Manuel d'installation télécharger pdf (Page 7)

LPe12000 and LPe12002 Hardware Installation Manual Page 4

Figure 3 shows one transceiver partly extracted and the other latched in place

Figure 3: Removing a transceiver

7. Observing ESD precautions, store the transceiver in an ESD-safe place.

8. Remove the mounting bracket screws from the top of the HBA.

Figure 4: Removing the Bracket

9. Remove the bracket and store it for future use.

10. Align the new mounting bracket tabs with the holes in the HBA.

11. Re-install the screws that attach the HBA to the bracket.

12. Re-install the transceiver by sliding it into the housing. When the latch engages, it clicks.

13. Push the bail back into place.

14. Remove the blank panel from an empty x8 or higher PCIe bus slot.

15. Insert the HBA into the empty slot. Press firmly until the adapter is seated.

16. Secure the HBA's mounting bracket to the case with the panel screw or clip.

17. Replace the computer case and tighten case screws.

The HBA is now installed in the PC and is ready for media attachment.

Note: Be careful not to push the bracket past the transceiver housing's grounding tabs.

Make sure the light emitting diodes (LEDs) are properly aligned with the holes in the

bracket.

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

Pas de commentaire

Emulex LightPulse LPe12000 Manuel d'installation Page 7